100 Vinyl Repair Adhesive 4 Oz

100 Vinyl Pool Repair Adhesive Helps You Out of Tough Situations!

Apply 100 Vinyl Adhesive 4 Oz to the patch and then fold the patch over upon itself. When you reach the damaged area under water, unfold the patch and apply it immediately to the liner, squeezing out all water bubbles. Do not disturb the patch for at least 48 hours.

100 adhesive-based repair kits should work at low temperatures; the cure rate will be affected though. At lower temperatures, more time will be necessary for the repair to completely dry. Boxer vinyl plastic repair tape (Cat. #10 and #30) is best used in temperatures above 70 degrees Fahrenheit. For quick and easy vinyl repairs without liquid adhesive, use boxer vinyl plastic pool patches.

100 Vinyl Adhesive, 4 oz can only be used with an applicator cap. A face mask or underwater goggles should always be used when going underwater to make repairs.

Regular Use Instructions:

• All surfaces must be clean
• Cut round corners on patch
• For inflatables and light gauge vinyl, apply adhesive to patch sparingly and press patch tightly to surface to be repaired
• Allow drying for 24 hours

For Underwater Repairs:

• Cut round corners on patch
• Apply adhesive to patch and fold patch over upon itself
• When you reach the damaged area under water unfold the patch and apply immediately to the liner, squeezing out all water bubbles
• Do not disturb patch for at least 48 hours
• Allow 4-7 days for full cure